Use of equipment:
Model:RS-600LH
This equipment is used for the testing of radiator modules, power supplies, servers, etc. It provides a cavity for the test environment under the condition of natural convection and no external air supply. The temperature control is achieved by the balance between the heater and the natural convection of the external environment.test environment.
The heating principle:
The infrared heater installed in the cavity heats the entire test environment by means of "thermal radiation"and "natural convection" heat transfer, By controlling the inputvoltage and adjusting the output power ratio of the heater, the purpose of constant temperature control in the cavity is achieved. With the optimized structural design, when the thermal equilibrium state is reached, the cavity test space has a uniform temperature and a very low wind speed. It can also isolate the wind speed interference of the external environment, which is analogous to the operation of the product under the condition of natural convection of indoor air and strict high temperature environment.
Specification:
●The chamber body is made of metal frame and 20 mmt transparent plastic plywood,Installed on the trolley frame with brake swivel wheel;
●Installed on the dimensions of the chamber:600x800x1200mm;
●There is a side door on the front and rear sides for the entrance and exit of the test piece.Reference door dimensions 600x800mm and 370x760mm;
●There are ventilating orifice plates on the upper and lower plates, which can be removed and replaced to allow air convection and maintain the temperature gradient in the temperature chamber;
●The platform is placed horizontally on two floors,grid structure,each floor is composed of 10 independent horizontal bars,In the horizontal position 30cm stage height adjustable position setting,the horizontal bar is detachable;
●Chamber heating heater,with thermal isolation safety cover;
●Room temperature+3℃~70℃;
●A set of 2-point average temperature display and control unit is attached;
●A 9-point temperature measurement report is attached when leaving the factory, Temperature uniformity:The heater is above 40cm,50% of the central space, and the standard deviation between the measured temperature at each point and the average temperature at 9 points is<2 ℃, 70℃,the standard deviation between the measured temperature at each point and the average temperature at 9 points is<3 ℃;
●With a universal power socket;
●Satefy device: with a protection temperature switch and a system-wide over-temperature power cut-off device, which can be reset manually;
●Power supply: AC220V,single-phade,20A;
●Dimensions:1000x960x1600mm;
Objects to be tested:
Radiator modules, servers, desktops, laptops, game consoled, Power supply, LED and other electronic products.
Features:
●Simulate the environmental test of the constant temperature chamber under the condition of natural convection and no external air supply;
●The temperature inside the chamber is adjusted in PID mode;
●Chamber temperature rance: room temperature+3℃~70℃;
●With a test piece placement platform with adjustable position,grid structure;